Return to BSD News archive
Newsgroups: comp.os.386bsd.questions
Path: sserve!newshost.anu.edu.au!munnari.oz.au!news.Hawaii.Edu!ames!agate!howland.reston.ans.net!usc!cs.utexas.edu!convex!news.oc.com!mistxt.oc.com!jongjay
From: jongjay@mistxt.oc.com (Jongjay Liou)
Subject: Re: Jumper settings for a WD8003E
Message-ID: <1993May17.202001.4298@ra.oc.com>
Sender: usenet@ra.oc.com
Organization: OpenConnect Systems, Dallas, TX
References: <C6M47r.99n@cs.bham.ac.uk>
Date: Mon, 17 May 1993 20:20:01 GMT
Lines: 51
In article <C6M47r.99n@cs.bham.ac.uk> R.O.Wells-SE0@cs.bham.ac.uk (Reuben O Wells) writes:
>Hello all,
>
>Can anyone tell me the correct jumper setting for a WD8003E
>Ethernet card for 386 bsd ? I have no manual and can only seem
>to get it to work on IRQ's 3-7 which is no good for 386 bsd
>which seems to want it on 2 or 9 !
>
>Thanks,
>
>Reuben Wells
>
>--
>row@cs.bham.ac.uk Tel: (+44) 21 449 9142
Case 1: if you have software configurable jumper & you have the floppy
that come with wd8003, then
Set up your WD8003 as
i/o base = 280h
irq = 2
ram = 0d0000
with the floppy (a:ezsetup) that ship with wd8003.
Case 2: if you have jumper-only wd8003e card, then manually jumper
the setting in your card like this:
THIS IS FOR EtherLink Board !
io base 9 8 7 6 5 4 3 2 1 0
H L H L L L L L L L
irq (on J6) 3 4 5 6 7 2
H
ram I am not sure about this.
Case 3: If you have software configurable board and you don't have
that floppy, tought luck guys!
Hope this can be helpful.
--
| Liou, Jongjay Networks UNIX System Administrator | OpenConnect |
| email: jongjay@mistxt.oc.com | 2711 LBJ Freeway |
| Tel: (214) 888-0615, 484-5200 Fax: (214) 888-0686 | Dallas, TX 75234 |
-----------------------------------------------------------------------------