Return to BSD News archive
Path: sserve!manuel!munnari.oz.au!uunet!gatech!usenet.ins.cwru.edu!agate!dog.ee.lbl.gov!nosc!manta!welsh
From: welsh@nosc.mil (Robert C. Welsh)
Newsgroups: comp.unix.bsd
Subject: Cannot install 0.1
Message-ID: <1992Jul27.214214.24706@nosc.mil>
Date: 27 Jul 92 21:42:14 GMT
Organization: Naval Ocean Systems Center, San Diego, CA
Lines: 51
I Need Help with 386BSD-0.1 install
When I try to boot TinyBSD it senses the following:
" pc0<color> at 0x60 irq 1 on isa
com1 at 0x3f8 irq 4 on isa
com2 at 0x2f8 irq 3 on isa
wd0<DTC6X80> at 0x1f0 irq 14 on isa
fd0 drives 0: 1.2M at 0x3f0 irq 6 drq 2 on isa
npx0 at 0xf0 irq 13 on isa "
The first time I try to boot after power up I get as far as
" changing root device to fd0a "
and a second later I get
" trap type 18 code = 0 eip = fe055532e cs = 8 eflags = 10246
cr 2 0 cpl 4040
panic: trap
hit reset please "
If I hit reset it goes through the above but further and comes up on the floppy.
I can then do most things in TinyBSD but as soon as I run install it gives me
almost the same messages as above (the differences are underlined):
" trap type 18 code = 0 eip = fe055532e cs = fe41008 eflags = 10246
------------
cr 2 dee0 cpl 4040
----
panic: trap
updating disks "
My hardware is as follows:
AST Premium/386C with 4 MB ram, cache disabled, shadow ram disabled, 387 co-
processor. (Premium 386 BIOS Ver 2.0)
Oak Technology VGA board (VGA BIOS 067 V1.03) with 512 memory
DTC 6280 ESDI disk controller running a Maxtor 4380EXT hard drive (340MB)
Hope someone can help as I have been following the group for months waiting
to get a shot at this (I just got the disk controller and drive)!
welsh@manta.nosc.mil
"Strange women, lying in ponds, distributing swords is no basis for a system
of government" - Monty Pyton