Return to BSD News archive
Path: sserve!manuel!munnari.oz.au!mips!mips!swrinde!cs.utexas.edu!uunet!uchinews!iitmax!pred
From: pred@iitmax.iit.edu (Predrag S. Bundalo)
Newsgroups: comp.unix.bsd
Subject: Tiny 386BSD installation problems.
Message-ID: <1992Jul29.185932.26506@iitmax.iit.edu>
Date: 29 Jul 92 18:59:32 GMT
Organization: Illinois Institute of Technology / Academic Computing Center
Lines: 32
I just got a copy of Tiny 386BSD and was "install"ing it onto my hard disk.
Everything went fine until it tried to reboot off the hard disk.
It would go into a continuous crash/reboot sequence spitting out the following
on the console:
>vm_fault(fe071c9c, 0, 1, 0) -> 1
>
>type, c code fe060000
>
>trap type 12 code = fe060000 eip = fe01276a cs = 8 eflags = 10282 cr2 4 cpl 1a
>panic: trap
>
>The operating system is saving a copy of RAM memory to device 1, offset 0
>(hit any key to abort): [amount left to save (MB)] --device bad
>system rebooting
My system type: 8MB memory, 100MB IDE drive, VGA, 33MHz BELTRON 386.
I assume there's something about the IDE drive it doesn't like. Anyone
understand how I can remedy this problem? I'm trying to get this system
set up for IIT as a demo for students.
Thanks,
--Pred
--
::: Predrag S. Bundalo Academic Computing Center :::
::: Illinois Institute of Technology Chicago, Illinois :::
...........................................................................
::: Internet: pred@{iitmax, elof}.iit.edu, syspredrag@minna.iit.edu :::
::: BITNET : syspredrag@iitvax.BITNET :::