Return to BSD News archive
Newsgroups: comp.unix.bsd Path: sserve!manuel!munnari.oz.au!mips!mips!sdd.hp.com!usc!venice!gumby.dsd.trw.com!eel.dsd.trw.com!gottloeb From: gottloeb@eel.dsd.trw.com (Jeffrey R. Gottloeb) Subject: Re: Tiny 386BSD installation problems. Message-ID: <1992Aug2.155120.6021@gumby.dsd.trw.com> Sender: news@gumby.dsd.trw.com Organization: TRW, INC. References: <1992Jul29.185932.26506@iitmax.iit.edu> Date: Sun, 2 Aug 1992 15:51:20 GMT Lines: 45 In article <1992Jul29.185932.26506@iitmax.iit.edu> pred@iitmax.iit.edu (Predrag S. Bundalo) writes: >I just got a copy of Tiny 386BSD and was "install"ing it onto my hard disk. >Everything went fine until it tried to reboot off the hard disk. > >It would go into a continuous crash/reboot sequence spitting out the following >on the console: > >>vm_fault(fe071c9c, 0, 1, 0) -> 1 >> >>type, c code fe060000 >> >>trap type 12 code = fe060000 eip = fe01276a cs = 8 eflags = 10282 cr2 4 cpl 1a >>panic: trap >> >>The operating system is saving a copy of RAM memory to device 1, offset 0 >>(hit any key to abort): [amount left to save (MB)] --device bad >>system rebooting > >My system type: 8MB memory, 100MB IDE drive, VGA, 33MHz BELTRON 386. > >I assume there's something about the IDE drive it doesn't like. Anyone >understand how I can remedy this problem? I'm trying to get this system >set up for IIT as a demo for students. > >Thanks, > >--Pred >-- >::: Predrag S. Bundalo Academic Computing Center ::: >::: Illinois Institute of Technology Chicago, Illinois ::: >.......................................................................... >::: Internet: pred@{iitmax, elof}.iit.edu, syspredrag@minna.iit.edu ::: >::: BITNET : syspredrag@iitvax.BITNET ::: I am having the same problem too. My system consists of: 486/33 ETEQ chipset 4Mb ram Seagate ST1239A BIOS type 47 w/954cyl, 12trk, 36sec Any help would be appreciated. Thanks in advance, Jeff Gottloeb gottloeb@trwrb.dsd.trw.com