*BSD News Article 3410


Return to BSD News archive

Newsgroups: comp.unix.bsd
Path: sserve!manuel!munnari.oz.au!uniwa!jeremy
From: jeremy@cowan.edu.au (J.LAIDMAN)
Subject: WD8003 probs - shared memory error
Message-ID: <jeremy.713070041@scorpion.ac.cowan.edu.au>
Sender: news@uniwa.uwa.edu.au (USENET News System)
Nntp-Posting-Host: 139.230.161.6
Organization: University of Western Australia
Date: Thu, 6 Aug 1992 03:00:41 GMT
Lines: 24

Any ideas?

When I boot 386BSD 0.1 I get an error:

	ec0: shared memory error (device conflict)

My ethernet card is an SMC elite 16 - WD8003 clone.  Settings are as follows:

	port:	0x240
	IRQ:	5
	base:	0xEC00

I've changed all of these settings, the only one that seems to make a diff
is the port address.  But when I change this, the message goes away
altogether.  What else could be using 0x240?  Is this the problem?

I've seen some postings that seemed to indicate IRQ 2 was mandatory without
recompiling the driver.  Is this so?  Any help would be appreciated.

---------------------------------------------------------------------
Jeremy Laidman, Computer Support Officer
Department of Computer Science                 Phone: (61 9) 370 6648
Edith Cowan University                         Fax:   (61 9) 370 2910
Perth, Western Australia                       j.laidman@cowan.edu.au