Return to BSD News archive
Path: sserve!newshost.anu.edu.au!harbinger.cc.monash.edu.au!yarrina.connect.com.au!news.mira.net.au!otis.apana.org.au!serval.net.wsu.edu!news.clark.edu!henson!reuter.cse.ogi.edu!uwm.edu!vixen.cso.uiuc.edu!howland.reston.ans.net!gatech!purdue!haven.umd.edu!cs.umd.edu!info.usuhs.mil!info.usuhs.mil!not-for-mail From: dobson@info.usuhs.mil (Michael Dobson) Newsgroups: comp.os.386bsd.questions Subject: Software config of SMC Elite 16 adapters? Date: 8 Dec 1994 13:51:37 -0500 Organization: Uniformed Services University of the Health Sciences Lines: 24 Message-ID: <3c7kjp$dg@info.usuhs.mil> NNTP-Posting-Host: info.usuhs.mil Has anyone figured out how to obtain/set the configuration of the SMC Elite 16 series of EtherNet adapters when they are jumpered for software configuration? The probe in FreeBSD fails to find these boards unless they are set to the values for ed0 or ed1, neither set of which are settable via jumpers. The two jumper settable configs are: port 0x280 irq 3 maddr 0xD0000 or port 0x300 irq 10 maddr 0xCC000 Using the SMC supplied DOS program EZStart, I determined that my card was set to: port 0x240 irq 10 maddr 0xC00000 and have built a kernel (thank you Poul for the kerndist!!) with the ed0 device preset to these values. It would be nice if probe could find these values and configure ed0 itself. Mike -- LCDR M. Dobson | NetNews Admin info.usuhs.mil Experimental Hematology Dept | dobson@info.usuhs.mil Armed Forces Radiobiology | Research Institute | I don't have enough rank to speak for DoD