Return to BSD News archive
Path: sserve!newshost.anu.edu.au!harbinger.cc.monash.edu.au!simtel!oleane!tank.news.pipex.net!pipex!swrinde!cs.utexas.edu!convex!darwin.sura.net!gwu.edu!seas.gwu.edu!dobrien From: dobrien@seas.gwu.edu (David O'Brien) Newsgroups: comp.unix.bsd.freebsd.misc Subject: Re: Help getting 3C503 up w/ 2.0.5 Date: 29 Jul 1995 09:04:55 GMT Organization: George Washington University Lines: 17 Message-ID: <3vctjn$lp@cronkite.seas.gwu.edu> References: <3v8il8$hgl@daffy.healthpartners.com> NNTP-Posting-Host: 128.164.9.3 X-Newsreader: TIN [version 1.2 PL2] Bryan T. Vold (btv@ldl.HealthPartners.COM) wrote: : I have been trying to get the 3C503 up. It gets recognized by the kernel, and : I have it jumpered to the correct settings (per HARDWARE file). I did get : NetBSD up a while back, and I had a hard time with that until I found the link0 : I get a bunch of references in the gateway field to "link#1". I assume this : is where the problem is. The FreeBSD.FAQ seems to be in error when it says : something about using the altphys or -altphys to change which port is used. : I haven't tried different hardware settings (yet). Should I need to? The I have run FreeBSD 2.0R through FreeBSD 2.0.5 june snap with a 3c503 card. It has an AUI port and a BNC port. I need to use the AUI port (for a UTP xcvr). Other than needing to add ``link2'', I've had no problems with the standard settings (ed0, irq 5, i/o 0x280, maddr 0xd800). -- David (dobrien@seas.gwu.edu)