Return to BSD News archive
Path: euryale.cc.adfa.oz.au!newshost.anu.edu.au!harbinger.cc.monash.edu.au!news.mel.connect.com.au!munnari.OZ.AU!spool.mu.edu!howland.reston.ans.net!gatech2!news.uoregon.edu!news.dacom.co.kr!nntp.coast.net!chi-news.cic.net!news.nd.edu!news From: ldb@cse.nd.edu Newsgroups: comp.unix.bsd.freebsd.misc Subject: SMC 8013EPC under FreeBSD? Date: 7 Dec 1995 19:36:02 GMT Organization: University of Notre Dame Lines: 29 Message-ID: <4a7fn2$q4e@news.nd.edu> Reply-To: ldb@cse.nd.edu NNTP-Posting-Host: pclsys51.dcrl.nd.edu X-Newsreader: IBM NewsReader/2 v1.2 I am requesting help with getting the SMC 8013EPC or WD8013EP cards to work under FreeBSD. I have been trying to use the ed driver to get this to work. Currently, ed0 is configured with port 0x280, irq 3, and iomem 0xd0000. iosize is set at 0, the drq is not set, and the flags are 0x0. ed1 is disabled. The other devices enabled are fdc0, wdc0, sc0, sio0, sio1, lpt1, and npx0. The jumpers on both cards are set as follows: The jumper labeled W1-Config (I/O, IRQ, RAM) is set for 280, 3, D0000. The jumper labeled W2-Rom Address is set to None/Soft. On boot, the messages are as follows: ed0; failed to clear shared memory at d0000 - check configuration ed0; not found at 0x280 These messages occur for both cards. Is anyone out there using either of these cards? Any help in getting these cards configured to work on my machine would be greatly appreciated. The machine is an IBM valuepoint P60, 60MHz Pentium, 16MB Ram, ISA/PCI bus, 523 MB IDE hard drive. The IDE controller, video card, and serial/parallel ports are built in. Currently, the Ethernet card is the only card in the machine. ANY ideas about how to get this card to work would be appreciated.