Return to BSD News archive
Xref: sserve comp.sys.ibm.pc.hardware:33463 comp.unix.bsd:6551 Newsgroups: comp.sys.ibm.pc.hardware,comp.unix.bsd Path: sserve!manuel.anu.edu.au!munnari.oz.au!hp9000.csc.cuhk.hk!uakari.primate.wisc.edu!caen!destroyer!news.iastate.edu!mhbrekke From: mhbrekke@iastate.edu (Monty H. Brekke) Subject: Re: Question on Diamond Clock Synthesizer Message-ID: <Bw3HsF.CCo@news.iastate.edu> Sender: news@news.iastate.edu (USENET News System) Organization: Iowa State University, Ames, IA References: <1992Oct11.045446.1020@fcom.cc.utah.edu> <Bvy0H3.Lwq@mudos.ann-arbor.mi.us> <1992Oct13.050754.4113@sinkhole.unf.edu> Date: Wed, 14 Oct 1992 04:57:50 GMT Lines: 22 In article <1992Oct13.050754.4113@sinkhole.unf.edu> shite@sinkhole.unf.edu (Stephen Hite) writes: > > I read a message that David Wexelblat posted recommending >for people to not use the "Batman" Diamond clock code (David got this >advice from Thomas Roell). I believe the reason was that it could >cause some kind of physical damage to either your monitor or card >(forgot which). I'll take Thomas's word for it... > Someone also warned me about the possibility of damaging the board by improperly setting the dot clock. This doesn't seem possible to me, but then again I don't know what Diamond's engineers had in mind when they designed the board. Has anyone out there been able to set the clock on the Stealth? If so, I would like to know if there is anything special that needs to be done, or if it can just be set as per the specs from S3. Thanks in advance. -- Internet : mhbrekke@iastate.edu