Return to BSD News archive
Received: by minnie.vk1xwt.ampr.org with NNTP id AA6453 ; Sat, 09 Jan 93 14:06:21 EST Newsgroups: comp.unix.bsd Path: sserve!manuel.anu.edu.au!munnari.oz.au!uunet!elroy.jpl.nasa.gov!sdd.hp.com!zaphod.mps.ohio-state.edu!pacific.mps.ohio-state.edu!linac!att!princeton!ernie.Princeton.EDU!bkc From: bkc@ernie.Princeton.EDU (Bruce Caruthers) Subject: Re: 386BSD install problem -- can't mount / Message-ID: <1993Jan12.005906.13693@Princeton.EDU> Originator: news@nimaster Sender: news@Princeton.EDU (USENET News System) Nntp-Posting-Host: ernie.princeton.edu Organization: Princeton University References: <1993Jan11.022758.10164@cs.wright.edu> <1993Jan11.224035.2823@fcom.cc.utah.edu> Date: Tue, 12 Jan 1993 00:59:06 GMT Lines: 24 In article <1993Jan11.224035.2823@fcom.cc.utah.edu> terry@cs.weber.edu (A Wizard of Earth C) writes: > >386BSD asks the controller about the drive geometry instead of believing >the CMOS settings. If your CMOS settings don't match what the controller >says, you have "translated drive" problems. Is there any way to tell 386BSD what the drive is set for? The settings for my drive are significantly different (manually configured long ago) from what Seagate reports when you call their number. It does, however, still fit a "type" listed in the BIOS (42, if I remember correctly). I am fairly certain that the current settings are *not* what the IDE controller reports. If I were to change the settings, it would require a lot of work re-doing the DOS partition and such. Thanks for any help (at least I know what is probably the problem, now, and can change it if I get desperate enough), -bkc (one of the previous posters of this kind of install problem) ============================================================================ bkc@{phoenix|cs}.Princeton.EDU caruthrs@thumper.Princeton.EDU Bruce Caruthers '93 Princeton University bkc@Sgi.COM "It is not death that a man should fear, but he should fear never beginning to live." -- Marcus Aurelius